Table of Contents
Advertisement
Headliner Removal/Installation
NOTE:
• W h e n p r y i n g w i t h a flat-tip screwdriver, w r a p it w i t h
protective tape to prevent damage.
• Take care not t o b e n d and scratch the headliner.
• Be careful not t o d a m a g e the dashboard and other
interior t r i m .
1. Remove these items: (Sedan (see page 20-75),
Coupe (see page 20-74))
• Door opening t r i m (both sides as necessary)
• Front pillar t r i m (both sides)
• Front seat belt upper anchor bolt (both sides)
2. Remove these items:
Sedan (see page 20-75)
• Center pillar upper t r i m (both sides)
Coupe (see page 20-74)
• Coat hanger (left side)
• Rear seat belt upper anchor bolt
• Quarter t r i m panel
3. Remove the rear w i n d o w antenna terminal cover
(see step 4 on page 20-49).
4. Remove the sunvisor (A) and holder (B) f r o m each
side. Disconnect the vanity mirror light connectors
(C) (driver's and passenger's for some models).
F a s t e n e r L o c a t i o n s
•
: E T s c r e w , 4
5 x 0.8 m m
3 I b f f t )
5. If equipped, remove the roof console.
- 1 Remove the lens (A).
- 2 Remove the screws.
- 3 Pull out the roof console (B), and disconnect
the spotlight connector (C).
F a s t e n e r L o c a t i o n s
C
6. Remove the caps (A), and remove the ET screws
and washers (B), then remove the grab handles (C)
(driver's and each passenger's).
F a s t e n e r L o c a t i o n s
•
: E T s c r e w , 8
5 x 0.8 m m
(cont'd)
20-79
Advertisement
Table of Contents
Troubleshooting
