Automatic Transmission
Shift Cable Adjustment
1. Shift the transmission into IE position.
2. Remove the console panel (see page 20-83).
3. Remove the nut securing the shift cable end (A),
then separate the shift cable end from the shift
lever assembly.
4. Rotate the socket holder (A) on the shift cable (B)
counterclockwise a quarter turn, then slide the
holder to remove the shift cable from the shift lever
bracket base (C).
NOTE: Do not remove the shift cable by twisting
the shift cable guide (D).
5. Push the shift cable until it stops, then release your
hand. Pull the shift cable back one step so that the
shift position is in E .
6. Turn the ignition switch ON (II), and verify that the
E position indicator light comes on.
7. Turn the ignition switch OFF.
8. Insert a 6.0 mm (0.24 in.) pin (A) into the
positioning hole (B) on the shift lever bracket base
through the positioning hole on the shift lever
assembly.
14-134