Trunk Pass-Through Cover Key Cylinder Replacement - Honda 2002 Accord Manual

Trunk Pass-through Cover Key Cylinder Replacement
NOTE:
• When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
• Take care not to scratch the cover.
1. Using a flat-tip screwdriver, pry the rear seat
handle (A) up at either hook portion (B) on forward
side of the trunk pass through cover (C). Then slide
the handle half-way up.
A
2. From trunk compartment side of the cover, using a
small screwdriver, press the inside hook (A) down
through the access hole (B).
3. While pressing the hook, pry the trunk handle (C)
up with a flat-tip screwdriver.
4. Remove the trunk handle (A) and rear seat handle
(B) together at the same time.
5. Remove the retainer clip (C), then remove the trunk
pass-through cover key cylinder (D) from the cover
(E).
6. Install the key cylinder in the reverse order of
removal, and note these items:
• Put the two handles together before installing
them on the trunk pass-through cover.
• Make sure the trunk pass-through cover opens
properly and locks securely.
20-131