Automatic Transmission - General Troubleshooting Information; How To Check For Dtcs With The Pgm Tester/Scan Tool - Honda 2002 Accord Manual

Hide thumbs Also See for 2002 Accord:
Table of Contents

Advertisement

«0
General Troubleshooting Information
How t o Check for DTCs w i t h the PGM Tester/Scan Tool
When the PCM senses an abnormality in the input or output systems, the S indicator in the gauge assembly will blink.
When the 16P Data Link Connector (DLC) (located next to the driver's side kick panel) is connected to the OBD II Scan
Tool or Honda PGM Tester as shown, the scan tool or tester will indicate the Diagnostic Trouble Code (DTC) when the
ignition switch is turned ON (II).
H O N D A P G M T E S T E R or
O B D II S C A N T O O L
If the B indicator or the MIL has been reported on, or if a driveability problem is suspected, follow this procedure:
1. Connect the OBD II Scan Tool (conforming to SAE J1978) or Honda PGM Tester to the 16P DLC. (See the OBD II
Scan Tool or Honda PGM Tester user's manual for specific instructions. If you are using the Honda PGM Tester,
make sure it is set to the S A E DTC type.)
2. Turn the ignition switch ON (II), and observe the DTC on the screen.
3. Record all fuel and emission DTCs, A/T DTCs, and freeze data.
4. If there is a fuel and emissions DTC, first check the fuel and emissions system as indicated by the DTC (except for
DTC P0700). DTC P0700 means there is one or more A/T DTC, and no problems were detected in the fuel and
emissions circuit of the PCM.
5. Get the anti-theft code for the radio, then write down the radio station presets.
6. Reset the memory with the PGM Tester or by removing the BACK UP fuse in the passenger's under-dash fuse/
relay box for more than 10 seconds.
7. Drive the vehicle for several minutes under the same conditions as those indicated by the freeze data, and then
recheck for DTCs. If the A/T DTC returns, go to the DTC Troubleshooting Index on page 14-7. If the DTC does not
return, there was an intermittent problem within the circuit. Make sure all pins and terminals in the circuit are tight,
and then go to step 8.
8. Enter the anti-theft code for the radio, reset the radio preset stations, and set the clock.
(cont'd)
14-3

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

2000 accord1999 accord1998 accordAccord 1998-2002Accord 1998Accord 1999 ... Show all

Table of Contents