Synchro Sleeve And Hub Inspection And Reassembly; Synchro Ring And Gear Inspection - Honda 2002 Accord Manual

Synchro Sleeve and Hub Inspection
and Reassembly
1. Inspect gear teeth on all synchro hubs and synchro
sleeves for rounded off corners, which indicate
wear.
2. Install each synchro hub (A) in its mating synchro
sleeve (B), and check for freedom of movement. Be
sure to match the three sets of longer teeth (C) (120
degrees apart) on the synchro sleeve w i t h the three
sets of deeper grooves (D) in the synchro hub. Do
not install the synchro sleeve w i t h its longer teeth
in the 1st/2nd synchro hub slots (E) because it w i l l
damage the spring ring.
NOTE: If replacement is required, always replace
the synchro sleeve and synchro hub as a set.
B
A
0 ©
Synchro Ring and Gear Inspection
1. Inspect the inside of the synchro ring (A) for wear.
2. Inspect the synchro ring teeth (B) for wear (rounded
off).
GOODT
WORN
3. Inspect the synchro sleeve teeth (C) and matching
teeth on the gear for wear (rounded off).
GOOD WORN
(cont'd)
13-41