Transmission Reassembly - Honda 2002 Accord Manual

Manual Transmission
Mainshaft Thrust Clearance
Adjustment (cont'd)
17. Zero a dial gauge (A) on the end of the mainshaft.
07GAJ-PG20110
18. Turn the mainshaft holder bolt (B) clockwise; stop
turning when the dial gauge (A) has reached its
maximum movement. The reading on the dial
gauge is the amount of mainshaft end play.
Do not turn the mainshaft holder bolt more than 60
degrees after the needle of the dial gauge stops
moving, this may damage the transmission.
19. If the reading is within the standard, the clearance
is correct. If the reading is not within the standard,
recheck the shim thickness.
Standard: 0 . 1 0 - 0 . 1 6 m m (0.004-0.006 in.)
Transmission Reassembly
1. Install the differential assembly in the clutch
housing.
2. Install the spring washer (A) and washer (B) over
the ball bearing (C).
Note the installation direction of the spring washer
(A).
3. Tape the splines of the mainshaft (E) with vinyl tape
to protect the seal.
Insert the mainshaft and countershaft (F) into the
shift forks (D), and install them as an assembly.
13-48