Table of Contents
Advertisement
Power Steering
Steering Gearbox Removal
Special Tools Required
Ball joint remover, 28 mm, 07MAC-SL00200
Note these items during removal:
• Using solvent and a brush, wash any oil and dirt off
of the valve body unit its lines, and the end if the
gearbox. Blow dry with compressed air.
• Be sure to remove the steering wheel before
disconnecting the steering joint. Damage to the cable
reel can occur.
1. Drain the power steering fluid (see page 17-14).
2. Raise the vehicle, and make sure it is securely
supported.
3. Remove the front wheels.
4. Remove the driver's airbag (see page 23-278).
5. Remove the steering wheel (see page 17-22).
6. Remove the steering joint cover.
7. Remove the steering joint bolts (A), disconnect the
steering joint by moving the steering joint (B)
toward the column.
8. Remove the cotter pin (A) from the 10 mm nut (B),
and loosen the nut.
0 7 M A C - S L 0 0 2 0 0
9. Separate the tie-rod ball joint and knuckle using the
special tool (see page 18-9).
17-30
Advertisement
Table of Contents
Troubleshooting
