Table of Contents
Advertisement
Flywheel Removal arid Installation
Special Tools Required
Ring Gear Holder 07LAB-PV00100
1. Remove the transmission (see page 13-4).
2. Remove the pressure plate and clutch disk.
3. Remove the 8 flywheel bolts, then separate the
flywheel from the crankshaft flange. After
installation, tighten the bolts in the sequence
shown.
0 7 L A B - P V 0 0 1 0 0
I n s p e c t r i n g g e a r
t e e t h f o r w e a r o r d a m a g e .
12 x 1.0 m m
1 0 3 N m (10.5 k g f m ,
7 6 I b f f t )
4. Install the transmission (see page 13-10).
Drive Plate Removal and
Installation
1. Remove the transmission (see page 14-114).
2. Remove the 8 drive plate bolts, then separate the
drive plate from the crankshaft flange. After
installation, tighten the bolts in the sequence
shown.
1 2 x 1.0 m m
7 4 N m (7.5 k g f m ,
5 4 I b f f t )
3. Install the transmission (see page 14-119).
7-7
Advertisement
Table of Contents
Troubleshooting
