Network Configuration, How To Use The Storeonce Gui; To Add A Custom Configuration - HP StoreOnce 2700 Installation And Configuration Manual

7 Network configuration, how to use the StoreOnce GUI

This chapter provides an overview on how to create a network configuration using the StoreOnce
GUI as an alternative to using the StoreOnce CLI.

To add a custom configuration

The following steps provide an overview of the process.
1. Create the configuration (or copy an existing one) and specify the DNS servers, as required.
2. Create the first Port Set and save the configuration. At this point you may decide to set up
Subnets for the Port Set, or to continue to set up all required Port Sets before defining Subnets
for each Port Set.
3. Create the required Subnets for each Port Set and save the configuration.
4. Validate the configuration.
5. If validation fails, correct errors. If it passes, either activate immediately at the prompt. Or
save the configuration and activate subsequently from the Custom Network Configuration List.
TIP: If configuring multiple VLANs, or reconfiguring a complex network, it may take several
minutes for the configuration to activate. During this time the Current Configuration page will show
the previous configuration and will be updated once activation is complete for the new configuration.
Step 1: Create new configuration and define DNS servers
1. On the Custom page, click on the New button.
2. Enter a Config Name. The name must be unique; spaces and special characters are not
permitted but underscore is allowed. The Config Description is optional. However, it is good
practice to put the configuration name into the description field because the description is
copied to the current configuration, when the configuration is activated.
3. Click on the Create button. At this point a new configuration will be opened for you to edit.
NOTE:
the Copy Existing drop-down list.
If there is an existing configuration that you wish to use as a template, select it from
To add a custom configuration 53