Installing And Cabling The Hp Storeonce Backup System; Installing The Rail Kit; Mounting The Hp Storeonce Backup System - HP StoreOnce 2700 Installation And Configuration Manual

2 Installing and cabling the HP StoreOnce Backup system

In this chapter:
Installing the rail kit (page 11)
Mounting the HP StoreOnce Backup System (page 11)
Attaching SFPs (page 12)
Connecting the hardware (page 15)
Connecting to the Capacity Upgrade Kit (if required) (page 18)
IMPORTANT:

Installing the rail kit

The supplied rail kits allow you to install the HP StoreOnce Backup system into square and round
hole racks for 1U and 2U servers. If mounting the HP StoreOnce Backup system into threaded hole
or telco racks, please refer to
hardware.
This installation is to be performed by qualified individuals who have knowledge of the procedures,
precautions, and hazards associated with equipment containing hazardous electrical circuits.
WARNING!
servers to be pulled out for servicing. However, the rails for any additional storage enclosures form
only a shelf for the unit to rest on. The enclosure is not attached to the rail by any other means.
Use extreme caution when pulling the enclosure out from the rack; it can slip and fall, causing
damage to the enclosure or injury. HP is not responsible for any damage or injury caused by the
mishandling of the enclosure .
WARNING!
leveling jacks (feet) extend to the floor and that the full weight of the rack rests firmly on the floor.
WARNING!
floor-bolting, anti-tip feet, ballast, or a combination of these as specified by the rack manufacturer
and applicable codes.
WARNING!
installation process. Use of the appropriate lifting device is recommended as an installation aid.
WARNING!
This makes the rack bottom-heavy and helps prevent it from becoming unstable.
WARNING!
load should not exceed 80 percent of the branch circuit rating.

Mounting the HP StoreOnce Backup system

WARNING!
installation process. Use of the appropriate lifting device is recommended as an installation aid.
NOTE: The HP StoreOnce 4700 Backup system consists of two units: a head server unit and a
storage enclosure. Make sure there is sufficient space to install both units adjacent to each other.
For both the HP StoreOnce 4700 and 4500 Backup system, plan ahead to ensure there is sufficient
space to add expansion enclosures at a later date.
See also the Safety Booklet on http://www.hp.com/go/storage/docs.
http://www.racksolutions.com
The rail kit that provides a secure mount to the server and rack, which allows the
Ensure that the rack is level and stable before working on the rack. Be sure the
Ensure that the rack has anti-tip measures in place. Such measures may include
Ensure that sufficient personnel are on hand to support the product(s) during the
Always load the rack from the bottom up. Load the heaviest items in the rack first.
Do not overload the branch circuit that provides power to the rack. The total rack
Ensure that sufficient personnel are on hand to support the product(s) during the
to purchase the required mounting
Installing the rail kit 1 1