Network Configuration Using Net Set Wizard - HP StoreOnce 2700 Installation And Configuration Manual

Network configuration using net set wizard

NOTE: See
configuration that we are creating in this example.
The net set wizard guides you through the network configuration on the StoreOnce Backup
system and configures all network settings for all subnets.
Before running the wizard collect and verify the required information, see
wizard (page
To make additions or modifications to an existing network configuration, do not use net set
wizard because this will overwrite the current configuration. Instead, use the net modify or
net add CLI commands, as described in
HP StoreOnce Backup system CLI Reference guide.
NOTE: If you wish to configure encryption on a subnet, you can only do this using the StoreOnce
CLI commands. It is not configurable using the wizard. See
Encryption (page
In the following example we shall use the net set wizard to support the following network
configuration:
Two DNS servers
One Port Set that uses the eth0 port only and will be used for a DHCP subnet.
A second Port Set that is used for the Backup Data subnets and uses the bonded pair of 10
Gbit ethernet ports, eth4 and eth5. This Port Set is VLAN-enabled. We shall set up one IPv4
VLAN subnet and one IPv6 VLAN subnet initially using the wizard, and then illustrate how to
modify the configuration to add a third VLAN subnet.
A third Port Set that is used for StoreOnce Catalyst Copy and Replication subnet across the
WAN and uses the bonded pair of 1 Gbit ethernet ports, eth2 and eth3. We wish to use
Mode 6 bonding on this Port Set, so it cannot be VLAN enabled. This subnet will also be
configured with the default gateway.
NOTE: The wizard runs continuously. You cannot interrupt it and save the configurations already
specified. However, for the purposes of this example, we have split it into sections to add notes.
1. First, we shall specify the DNS servers and create Portset1 on eth0. We shall keep this as
DHCP in line with the Quick Install option. In reality, you are more likely to re-configure this
Port Set with static IP addresses, but we shall illustrate this as a post-installation example. See
Modifying a network configuration (page 48)
# net set wizard
StoreOnce Network Configuration Wizard
--------------------------------------
This Wizard will guide you through the configuration of
network settings on your StoreOnce Backup System.
If you wish to make additions or modifications to an existing
network configuration without having to reconfigure all settings,
use the 'net modify' or 'net add' commands instead.
See the User Guide guide for physical port layout details.
The wizard consists of the following steps:
Step 1) Set system wide DNS server addresses (optional) and cluster size (if multi-node)
Step 2) Configure network settings for available network adapters
Step 3) Save and apply all network settings
Type 'quit' + ENTER at any time to exit wizard.
Step 1) Set system wide DNS server addresses (optional) and cluster size (if multi-node)
----------------------------------------------------------------------------------------
Enter a list (max 3) of DNS servers separated by commas; this list may be blank.
The IP version used here must match that used on the management interface later on.
For example, for IPv4: 192.168.1.100,192.168.3.100
Example network environment (page 34)
39).
49).
for a diagram illustrating the network
Modifying a network configuration (page 48)
To add Data in Flight
for more information.
Network configuration using net set wizard
Before running net set
and the
41