Modifying The Current Network Configuration; Best Practice - HP StoreOnce 2700 Installation And Configuration Manual

Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Finish Wizard: Yes
*Step Complete* Do you want to :
1 = Finish wizard and apply settings
2 = Go back to previous step: Step 2)
3 = Go back to start of present step: Step 3)
4 = Quit wizard and lose all settings
-->1
<--Navigation: Finish wizard and apply settings
Successfully saved network configuration as: net_wizard
Application of the network configuration is now in progress.
This process may take some time to complete.
You can check on its status with the following command:
net activate status
*****************************************************
You have successfully configured the network settings
on your StoreOnce Appliance.
*****************************************************
TIP: If the network configuration is complex, it may take a little time for the settings to become
active. After completing the wizard use the following StoreOnce CLI command to check
progress:
net activate status
NOTE: For further examples of configuring the network using both the wizard and individual
StoreOnce CLI commands see also

Modifying the current network configuration

NOTE: It is not possible to activate a new configuration if storage addition is in progress.
After upgrade, depending upon the initial configuration, you may wish to:
Create a new Port Set to add a further subnet. This option only applies if you still have ports
available to configure as Port Sets after running the wizard.
Modify an existing Port Set to support an IPv4 and an IPv6 subnet.
Modify an existing Port Set to support multiple VLAN subnets. As long as the Port Set for the
subnet is already VLAN enabled, this is simply a question of adding VLAN subnets to the Port
Set.
Modify the Ethernet Framesize of a Port Set. The net set wizard always assigns the default
value of 1500 bytes. This may be edited to any value between 1280 (minimum) and 9000
(maximum) bytes. The easiest way to edit the Framesize is to use the StoreOnce GUI, as
described in the HP StoreOnce Backup User Guide for your product.
Add Data-In-Flight encryption to a subnet. This option requires installation of the Security Pack
license.
NOTE: A ll of these tasks may be carried out simply from the StoreOnce GUI. If you wish to use
the StoreOnce CLI, refer to the HP StoreOnce Backup system CLI Reference Guide for syntax
examples. The only worked example included in this guide describes how to configure IPsec.

Best practice

The recommended best practice is:
48 Network configuration, how to use StoreOnce CLI commands
(default)
More networking examples (page 114).