HP StoreOnce 2700 Installation And Configuration Manual page 42

For example, for IPv6: 2001:DB8::0,2001:DB8::1
-->172.1.1.100,172.1.2.100,2001:DB8::1
<--DNS servers: 172.1.1.100,172.1.2.100,2001:DB8::1
*Step Complete* Do you want to :
1 = Go to next step: Step 2) (default)
2 = Go back to start of present step: Step 1)
3 = Quit wizard and lose all settings
-->1
<--Navigation: Go to next step: Step 2)
Step 2) Configure network settings for available network adapters
-----------------------------------------------------------------
Select the type of configuration for this subnet
(Selecting "bonded" here will create a "Port Set" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->1
<--Bonded/Single: Single port
Select network adapter :
1 = eth0 (1 Gig) (default)
2 = eth1 (1 Gig)
3 = eth2 (1 Gig)
4 = eth3 (1 Gig)
5 = eth4 (10 Gig)
6 = eth5 (10 Gig)
-->1
<--Single Port: eth0 (1 Gig)
Is this subnet on a Virtual LAN?
1 = No (default)
2 = Yes
-->1
<--VLAN/Not VLAN: No
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->1
<--DHCP/Static: DHCP
Do you want to configure a static default gateway for this subnet or get the gateway information from
DHCP?
--------------------------------------------------------
Note for ipv6 DHCP servers a static gateway is required.
--------------------------------------------------------
1 = Gateway obtained from DHCP server (default)
2 = Set gateway manually (this may be blank if no gateway is required)
-->1
<--Gateway: Gateway obtained from DHCP server
Do you want to configure the network domain name or get the domain name from DHCP?
1 = Domain name obtained from DHCP server (default)
2 = Set domain name manually (e.g. mydomain.local - this may be blank if no domain name is required)
-->1
<--Domain Name: Domain name obtained from DHCP server
----------------------
Network: subnet_1
----------------------
IP Addresses: dhcp
Netmask/Prefix: dhcp
Domain Name: dhcp
Gateway: dhcp
VLAN tag:
Port Set: Port Set_1 with these interfaces: eth0, Framesize: 1500
Encryption Links:
Bonding Mode: Not applicable
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
42 Network configuration, how to use StoreOnce CLI commands