Connecting The Hardware; Connecting The Hp Storeonce 4700 Backup System - HP StoreOnce 2700 Installation And Configuration Manual

Connecting the hardware

1. Use the supplied power cord(s) to connect the HP StoreOnce Backup system to the rack power
supply. This HP-approved cord is appropriate for your specific geographic region.
HP StoreOnce 2900, 4500 and 4700 Backup systems have a redundant power supply (this
also applies to the HP StoreOnce 2700, if a second power supply has been purchased and
installed). Make sure that both power cords are connected.
For detailed safety information, see the Safety Guide. Information about accessing this guide
can be found on the flyer included with your product.
2. HP StoreOnce 4700 Backup only: The storage enclosure supplied in the same pallet as the
head server unit must be connected to the HD SAS port on the RAID controller in slot 1, as
described in
3. For ease of installation connect LAN Port 1 on the head server unit to a 1 Gbit ethernet network
switch on a DHCP-enabled network. The appliance will use the default configuration and will
be available on the network after power up. You can then use the HP StoreOnce CLI commands
to further configure the network, as described in
CLI commands (page
NOTE:
to the 1 Gbit ethernet network switch. 100 Base-T Ethernet will limit performance.
If you are not using the quick install option, connect the required network port(s) and also
connect a console and keyboard to the video and USB connectors on the rear of the unit (see
drawings below for your product). You will need to configure the appliance manually after
power up so that it can be accessed on the network, see also
understanding the concepts (page 30)
4. If installing Capacity Upgrade enclosures at the same time, make sure they are cabled to the
HP StoreOnce Backup system and the rack power supply, as described in
Capacity Upgrade Kit (if required) (page
5. Power up the HP StoreOnce Backup system. See
Management system (page
NOTE: The HP StoreOnce Backup system also supports iLO4.

Connecting the HP StoreOnce 4700 Backup system

Figure 6 Rear view of the HP StoreOnce 4700 Backup system
1. RAID controller 1
3. FC card 2
5. 10 Gbit ethernet card
7. Power supply bay 2
9. Video/monitor connector
Connecting the first storage enclosure at installation (page
38).
Use any CAT-5E or better network cable (also supplied with the product) to connect
24).
Network configuration, how to use StoreOnce
Network configuration,
18).
Powering on and managing the StoreOnce
2. FC card 1
4. RAID controller 2
6. Power supply bay 1
8. USB connectors (4)
10. iLO4 port, do not use for data connection
16).
Connecting to the
Connecting the hardware 15