Accessing The Storeonce Backup System Over Sftp - HP StoreOnce 2700 Installation And Configuration Manual

Service Sets Status
------------ ------
Set 1
4. Once the discovery process is complete, run the following command in order to format the
storage LUN with file system segments:
hardware add storage
This command will expand the filesystem to use the storage. The process can take a long time
to complete and the new capacity will not be available until it is finished.
5. Monitor the expansion using the following command:
system show status
This command will return either of the following after an add command has been sent:
Adding X,XXXGB... or Formatted XXGB
The following output is an example; the values shown may not match your appliance specific
values.
# system show status
Status
------
Formatted 15,070.76GB
Service Sets Status
------------ ------
Set 1

Accessing the StoreOnce Backup system over SFTP

There are a number of occasions when you may need to access the HP StoreOnce Backup system
over SFTP:
To transfer software update packages to the correct location in the StoreOnce folder structure.
To access files that are generated and stored in the StoreOnce folder structure, such as the
support tickets (in the /tickets folder), software upgrades (in the /repository folder)
and the saved configurations (in the /config folder).
Figure 24 StoreOnce folder structure
Notes
-----
Running
Notes
-----
Running
Accessing the StoreOnce Backup system over SFTP 63