Hot-Plug Drive Leds; Server Units - HP StoreOnce 2700 Installation And Configuration Manual

Hot-plug drive LEDs

Server units

The hot-plug drives in head server units have four LEDs.
HP StoreOnce 2700 Backup: all four drives are as illustrated below, this model does not
support expansion shelves
HP StoreOnce 4500 Backup: all twelve drives in the head server unit are as illustrated below,
the disks in the expansion shelf have a different carrier
HP StoreOnce 4700 Backup: the two drives in the head server unit are as illustrated below,
the disks in the expansion shelves have a different carrier
Figure 34 Drive LEDs (head server units)
1. Locate
2. Activity ring
3. Do not remove
4. Drive status
106 Understanding LEDs
Solid blue = The drive is being identified by a host application.
Flashing blue = The drive carrier firmware is being updated or requires an update.
Off = No drive activity
Rotating green = Drive activity
Solid white = Do not remove the drive. Removing the drive causes one or more of the
logical drives to fail.
Off = Removing the drive will not cause a logical drive to fail.
Off = The drive is not configured by a RAID controller.
Solid green = The drive is a member of one or more logical drives.
Flashing green = The drive is rebuilding or performing a RAID migration, stripe size
migration, capacity expansion, or logical drive extension.
Flashing amber/green = The drive is a member of one or more logical drives and predicts
the hard drive will fail.
Flashing amber = The drive is not configured and predicts the hard drive will fail.
Solid amber = The drive has failed.