Fibre Channel Card Leds - HP StoreOnce 2700 Installation And Configuration Manual

Figure 37 10 Gbit ethernet card LEDs (example shows HP StoreOnce 4700 Backup)
1. Link
2. Activity

Fibre Channel card LEDs

There are three LEDs adjacent to each FC port, if you have an HP StoreOnce Backup system that
supports Fibre Channel.
Table 1 1 FC card LEDs
Yellow LED
Off
On
Flashing
Alternately flashing
Off
Off
Off
Off
On
Flashing
108 Understanding LEDs
Green LED Amber LED
Off Off
On On
Flashing Flashing
Alternately flashing Alternately flashing
Off On
Off Flashing
On Off
Flashing Off
Off Off
Off Off
Off: No link to the adapter is established. The adapter is
not receiving power or the cable connection is faulty
On (yellow): Link to the adapter is established. The adapter
is receiving power and the cable connection is good.
Flashing green: Ongoing network data activity. The adapter
is sending or receiving network data at up to 10 Gb/s
Off: No network data activity or no connection.
Activity
Power Off (OK)
Power on before or after software initialization.
Awaiting HBA software initialization.
Power on after software initialization. Link not
initialized.
Software fault (OK)
Connected at: 2 Gb/s
Activity at 2 Gb/s (OK)
Connected at 4 Gb/s
Activity at 4 Gb/s (OK)
Connected at 8 Gb/s
Activity at 8 Gb/s