Adding Disks For Capacity Expansion (Storeonce 2900 Only) - HP StoreOnce 2700 Installation And Configuration Manual

Adding disks for capacity expansion (StoreOnce 2900 only)

The Capacity Expansion kit contains six 4TB disks, which are installed in slots 7 to 12.
1. Remove the blanking plates from the disk bays.
NOTE:
Figure 14 Removing the blanking plates
2. Push the hard drive assembly into each drive bay (1) until it stops (2) and press the HDD
carrier latch (3) inward until it clicks.
Figure 15 Installing the hard disks
3. Attach the front bezel when all six disks are installed.
22 Installing and cabling the HP StoreOnce Backup system
You must install all six disks at the same time.