Table of Contents
Advertisement
If this command is successful, you will see a display similar to figure
2-3. The status message shows that the default configuration file has
been loaded. If the command is not successful, you will be given an
error message and returned to the HP-UX prompt. Error messages are
described in the Softkey Interface Reference manual.
Using the Default
The default emulator configuration is used with the following
examples. In the case of H8/338 emulator, the address range 0 hex
Configuration
through 3fff hex is mapped as emulation ROM and fd80 hex through
ff7f hex as emulation RAM. In the case of H8/325 emulator, the
address range 0 hex through 7fff hex is mapped as emulation ROM and
fb80 hex through ff7f hex as emulation RAM.
On-Line Help
There are two ways to access on-line help in the Softkey Interface. The
first is by using the Softkey Interface help facility. The second method
allows you to access the firmware resident Terminal Interface on-line
help information.
Softkey Driven Help
To access the Softkey Interface on-line help information, type either
"help" or "?" on the command line; you will notice a new set of
softkeys. By pressing one of these softkeys and <RETURN>, you can
cause information on that topic to be displayed on your screen. For
example, you can enter the following command to access "system
command" help information.
? system_commands <RETURN>
The help information is scrolled on to the screen. If there is more than
a screenful of information, you will have to press the space bar to see
the next screenful, or the <RETURN> key to see the next line, just as
you do with the HP-UX more command. After all the information on
the particular topic has been displayed (or after you press "q" to quit
scrolling through information), you are prompted to press <RETURN>
to return to the Softkey Interface.
Getting Started 2-9
Advertisement
Table of Contents
