Attaching Sfps, Storeonce 2900, 4500 And 4700 Only - HP StoreOnce 2700 Installation And Configuration Manual

1. Install the rails in the rack, as required. Follow the instructions provided separately with the
rail kits.
2. Slide the HP StoreOnce Backup system into position in the rack and secure it to the rack rails
using thumbscrews on the unit's front bezel.
IMPORTANT:
information, such as the MAC address and default network name. It also contains the iLO
password for the system. Make a note of this information before you install the HP StoreOnce
Backup system in the rack. See
passwords and best practices after initial configuration.
The following figure illustrates how to mount the HP StoreOnce Backup system, using the HP
StoreOnce 2700 model as an example.
Figure 1 Secure the HP StoreOnce Backup system to the rack
NOTE:
you have purchased the optional second power supply, be sure to install it before continuing
with the installation.

Attaching SFPs, StoreOnce 2900, 4500 and 4700 only

The Accessory Kit supplied with the HP StoreOnce 4500 and 4700 Backup system contains the
appropriate number of 8Gb Short Wave FC SFP+ and 10Gb SR SFP+ transceivers.
The Accessory Kit supplied with the HP StoreOnce 2900 Backup system contains the appropriate
number of 10Gb SR SFP+ transceivers.
Unpack these and connect them to the corresponding ports on the rear of your product as shown
below.
12 Installing and cabling the HP StoreOnce Backup system
The label on the top of the HP StoreOnce Backup system contains useful identity
Password best practices (page 27)
The HP StoreOnce 2700 Backup system is supplied with a single power supply. If
for more information about