HP StoreOnce 2700 Installation And Configuration Manual page 45

Enter domain name :
-->manuf.mycompany.net
<--Domain name: manuf.mycompany.net
----------------------
Network: subnet_3
----------------------
IP Addresses: 2001:DB8::10
Netmask/Prefix: 64
Domain Name: manuf.mycompany.net
Gateway: 2001:DB8::100
VLAN tag: 23
Port Set: Port Set_2 with these interfaces: eth4 eth5, Framesize: 1500
Encryption Links:
Bonding Mode: 4 (Link Aggregate Control Protocol (LACP) Bonding)
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
3. At this point, you have configured the network sufficiently to enable access to the StoreOnce
Management CLI and GUI, and to target backup from media servers on the specified IPv4
and IPv6 VLAN subnets. We shall continue with the wizard to complete initial network
configuration by creating a third (and final) Port Set on a pair of 1 Gbit ethernet ports, eth2
and eth3, which will use bonding mode 6 and, therefore, cannot be VLAN-enabled. This Port
Set will be used for the StoreOnce Catalyst Copy and Replication subnet, which will also be
configured with the default Gateway.
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new physical port set
3 = Yes - a new subnet on a new VLAN on the same physical port set
4 = Yes - a new subnet on same VLAN on the same physical port set(IPv4)
-->2
<--Another subnet: Yes - on a new physical port set
Select the type of configuration for this subnet
(Selecting "bonded" here will create a "Port Set" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->2
<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)
Select bond configuration :
1 = eth1, eth2 (1 Gig) (default)
2 = eth1, eth3 (1 Gig)
3 = eth2, eth3 (1 Gig)
4 = eth1, eth2, eth3 (1 Gig)
-->3
<--Bonding: eth2, eth3 (1 Gig)
Select the desired bonding mode :
-----------------------------------------------------------------
Note that if you select bonding mode 6, you will not subsequently
be able to add VLAN networks to this Port Set.
-----------------------------------------------------------------
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->3
<--Bonding Mode: Mode 6 - Active Load Balance Bonding
-------------------------------------------------------------
Portsets with bonding mode 6 may not have VLANs.
-------------------------------------------------------------
Is this subnet on a Virtual LAN?
1 = No (default)
-->1
<--VLAN/Not VLAN: No
Network configuration using net set wizard 45