HP StoreOnce 2700 Installation And Configuration Manual page 43

<--Configuration okay: Yes
2. At this point, you have configured the network sufficiently to enable access to the StoreOnce
Management CLI and GUI. If preferred, you could complete the network wizard and carry
out the rest of the network configuration using the StoreOnce CLI commands. The wizard
would complete as described in step 4. (Note, these steps are artificial to enable a description
of what is happening. The wizard runs continuously.) For the purposes of our example, we
shall continue to create a second Port Set on the pair of 10 Gbit ethernet ports, eth4 and eth5,
which will use bonding mode 4 and be VLAN-enabled. We shall use the wizard to create
two VLAN subnets on this Port Set; one IPv4 VLAN using the VLAN tag 22 and one IPv6 VLAN
using the VLAN tag 23.
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new physical port set
-->2
<--Another subnet: Yes - on a new physical port set
Select the type of configuration for this subnet
(Selecting "bonded" here will create a "Port Set" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->2
<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)
Select bond configuration :
1 = eth1, eth2 (1 Gig) (default)
2 = eth1, eth3 (1 Gig)
3 = eth2, eth3 (1 Gig)
4 = eth1, eth2, eth3 (1 Gig)
5 = eth4, eth5 (10 Gig)
-->5
<--Bonding: eth4, eth5 (10 Gig)
Select the desired bonding mode :
-----------------------------------------------------------------
Note that if you select bonding mode 6, you will not subsequently
be able to add VLAN networks to this Port Set.
-----------------------------------------------------------------
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->2
<--Bonding Mode: Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
Is this subnet on a Virtual LAN?
1 = No (default)
2 = Yes
-->2
<--VLAN/Not VLAN: Yes
Enter VLAN tag (an integer between 2 and 4094 inclusive) :
-->22
<--VLAN Tag: 22
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->2
<--DHCP/Static: Static
Enter an IP address for this network:
-->10.1.1.16
<--Static IP address: 10.1.1.16
Enter network mask or network prefix length :
For IPv4 networks, you may enter either a netmask or a length;
For IPv6 networks, you must enter a network prefix length.
-->255.255.255.0
<--Network mask/length: 255.255.255.0
Network configuration using net set wizard 43