HP StoreOnce 2700 Installation And Configuration Manual page 54

4. As appropriate, select IPv4 or IPv6 for any DNS servers and enter the required addresses in
the appropriate format. Click Save.
Table 5 Network Configuration IP protocol and DNS fields
Field name
Name of the configuration
Protected
DNS server details: These settings apply across all other settings.
Protocol: IPv4 or IPv6
DNS Address 1/2/3
Step 2: Create Port Sets
1. On the Port Set bar click Add to create the first Port Set.
2. Enter a name for the Port Set and select the ports to use. Available ports depend upon the
model of StoreOnce Backup system and whether ports have already been assigned. Only
those ports that are available are active for selection; others are greyed out if they are already
in use.
Click on the Show Port Picture link to display a picture of the rear of the model with ports
labeled.
54 Network configuration, how to use the StoreOnce GUI
Description
This reflects the name of the configuration selected in the
list.
This checkbox is always greyed out for the Current and
Factory Default configurations because they cannot be
edited. Custom configurations can be edited and the
checkbox is active to indicate their protection status.
The radio button selected defines the Internet Protocol for
the DNS servers.
Up to three IPv4 and/or IPv6 DNS addresses may be
defined. The format of the address details is as appropriate
for the protocol selected. For more information, see "DNS
Servers" in "Network configuration components" (page 30).