Storeonce Gui Status Page; Example 3 - HP StoreOnce 2700 Installation And Configuration Manual

# net show status all
Subnet Status Overview
Subnet HPDA3DE52E99 public_IPv4 status: up
Subnet HPDA3DE52E99 public_IPv6 status: up
------------------------
Node Name: HPDA3DE52E99
Default Domain Name: mydomain.com mydomain.com
Default Gateway: 16.26.128.1 fcda:cd45:5ab0:862::0
Default Subnet: public_IPv4 public_IPv6
DNS: fcda:cd45:5ab0:123::99
Subnet: public_IPv4
Status: up
IP Address: 16.26.134.87
Netmask/Prefix: 255.255.240.0
Domain Name: mydomain.com
Gateway: 16.26.128.1
Mac Address: 00:50:56:9A:79:12
Interface: eth0
Bonding mode: Not applicable
VLAN tag: Not used
Connection Speed: 1 Gig
Framesize: 1500
Subnet: public_IPv6
Status: up
IP Address: fcda:cd45:5ab0:862::92
Netmask/Prefix: 64
Domain Name: mydomain.com
Gateway: fcda:cd45:5ab0:862::0
Mac Address: 00:50:56:9A:79:12
Interface: eth0
Bonding mode: Not applicable
VLAN tag: Not used
Connection Speed: 1 Gig
Framesize: 1500
Command Successful
#

StoreOnce GUI Status page

Figure 39 Example Status page for an IPv4 and an IPv6 static subnet on the same interface

Example 3

This example creates two subnets on different network interfaces. It configures a static IPv6 address
on interface eth0 and a static IPv6 address with VLAN tag on interface eth1.
NOTE: The following StoreOnce CLI commands create a network configuration called v6_vlan.
Once activated this configuration becomes the current network configuration but also continues
to exist as a Custom network configuration.
=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2014.08.13 15:23:44 =~=~=~=~=~=~=~=~=~=~=~=
net create config v6_vlan dns fcda:cd45:5ab0:862::99 description "Two subnets
Static IPv6 address on interface eth0 and a static IPv6 address with VLAN tag on interface eth1."
Command Successful
# net create portset v6_vlan Port_Set_1 ports eth0 vlansupport no framesize 1500
Command Successful
on different network interfaces.
Example 3 1 17