HP StoreOnce 2700 Installation And Configuration Manual page 76

Initial configuration
Please refer to the HP StoreOnce Backup system Installation and Configuration guide for cabling
instructions and zoning recommendations. The following process describes the steps to complete
configuration.
1. Go to the Fibre Channel Settings tab and, in the bottom section of the screen (Devices), locate
the World Wide Name information for each port on the StoreOnce Backup system. This is the
information that you need to zone the client with the StoreOnce Backup system.
2. Also look at the Identifier Name in the top section of the screen. This is the FC address of the
StoreOnce Backup system and is used to identify the StoreOnce Backup system in the backup
application. It is in the format CoFC-<device-id>; if preferred, you may provide an Identifier
Alias, which will be easier to identify from the backup application.
3. The Target Ports section in the center of the screen is identical to the settings that you can
configure for VTL target devices over FC. The default values are recommended, but you may
edit Speed and Topology.
NOTE:
in the StoreOnce VTL section of the GUI, if you are backing up to StoreOnce VTL library target
devices over Fibre Channel. Port Speed or Topology settings, defined on either page, apply
to all target devices being backed up over Fibre Channel.
4. In the Devices section locate the Number of Logins and Devices per Initiator Port for each port.
These values determine the number of concurrent backup and restore connections allowed on
each FC port on the HP StoreOnce Backup system.
The Number of Logins defines the number of client-side ports that are zoned to be able
to connect to that port on the StoreOnce Backup system. This cannot be edited.
The Devices per Initiator Port value determines the number of backup and restore
connections that are allowed — for each client login — to that port on the StoreOnce
Backup system. This value should be increased if multiple concurrent backup streams are
required. Note that the maximum allowed is 64.
76 Fibre Channel installation and configuration
These Fibre Channel settings apply to the whole appliance and can also be edited