8.3.6
Cable routing
Requirements:
• 4 mm Allen key
•
•
•
Remove the rear and the centre cover as described in chapters 8.1.1 and Fehler!
Verweisquelle konnte nicht gefunden werden. .
•
In the case of the lifter cabling, also remove the front cover as described in chapter 8.1.3.
•
Lead the cables on the modules fitted at the rear (power module and actuator module) through
the recess in the battery flap under the actuator module to the cable bridge (1).
•
Lead the cables inside the covers over the cable bridge (1).
•
Fasten the cables with the cable clamps (2). The cable clamps on the front side of the battery
compartment for the cables of the optional lifter are not seen in the picture.
•
60