Updating Software; Replacing Usb Charger; Checking Cable; Cable Routing - Invacare TDX SP2 Series Service Manual

3. Position operating hour counter in cut-out.
4.
5. Reposition retaining frame (6).
6. Place mounting bracket (2) on threaded rod (3) so that
mounting bracket presses retaining frame on shroud.
7. Place locking washer (4) and nut (5) on threaded rod.
8. Tighten nut hand-tight.
9. Install rear shroud again. See chapter 6.9 Shrouds,
page 41.

6.10.5 Updating Software

See LiNX service manual.

6.10.6 Replacing USB charger

• 4 mm Allen wrench
When charger overheats, it stops working. Rail
under the seat serves to dissipate heat.
• Always mount USB charger in first third of the
rail of telescopic seat frame.
Removing USB charger
1. Loosen and remove screw D including washer C.
2. Take off USB charger B from rail of telescopic seat
frame A.
3. Replace USB charger.
Installing USB charger
1. Install parts in reverse order.
1532486-N

6.10.7 Checking cable

• 5/8" Allen key
• Size 2 Phillips screwdriver
• Oblique pliers
• Cable ties
1.
Remove shrouds, disconnect battery plugs and pull
batteries out of battery compartment as described in
6.11.3 Making Batteries Accessible, page 46.
2. Check fuse cable (1), battery cable (2) and battery plug
(3) for visible damage and crushing locations.
3. Replace any damaged cables.
4.
The position of the plugs is different for
other electronic modules. The procedure for
checking is otherwise identical. The position
of the plugs is described in revision 11 of this
manual or in LiNX Service Manual".
Check all cables for visible damage and crushing
locations. Replace any damaged cables.
5. Pull each plug carefully. Plug should not come out
of socket.
6. If one of plugs is loose, press it back into socket with
light pressure. Plug must engage.
7. Checked to make sure that plug is now firmly in its
socket. If not, repeat previous step.
8. Install parts in reverse order.
9. Test all functions.

6.10.8 Cable routing

• Size 2 Phillips screwdriver
• Oblique pliers
• Cable ties
1. Remove rear shroud as described in 6.9.2 Replacing
Rear Shroud (Without Operating Hour Counter), page
41.
2. When routing cables in rear section, make sure that
rear wheel stabilizers are movable.
3.
Fix cable with cable ties at locations marked A.
Service
45