8.4.3
Replacing the actuator module on the battery compartment
Replacement is described in the following section based on the example of a mobility aid with an
optional lighting PCB and an optional actuator module.
Requirements:
• 4 mm Allen key
•
Removing the tilt module:
•
If possible, use the lifter to move the seat to the uppermost position.
•
Remove the rear and the centre cover as described in chapters 8.1.1 and Fehler!
Verweisquelle konnte nicht gefunden werden..
•
Carefully note the location of the cable and the connection locations of the various plugs.
Either mark each plug and socket, or take a photograph with a digital camera.
•
The pictures show the power module (4), the optional lighting PCB (2) and the optional
actuator modules (1) & (3).
•
Pull the plug (1) out of the actuator module.
•
Undo the two Phillips screw (2).
64