Invacare Storm Service Manual page 104

•
Attach the washers to the torx screws from the rear.
•
Fit the headrest holder (3) onto the torx screws.
• Attach further washers to the torx screws.
•
Fit the nuts (1) to the torx screws.
•
Tighten the torx screws and the nuts using a T30 torx wrench and a 10 mm socket spanner.
•
Insert the headrest (4) in the headrest holder.
•
Fit the thumb screw (2) and tighten it.
• Move the back plates back to the old width.
•
Tighten the three Allen screws on the back plates.
•
103