Section 10-Tilt; Removing/Installing The Trigger Release Lever With Cable - Invacare Solara 3G Service Manual

SECTION 10—TILT
After ANY adjustments, repair or service and before use, make sure all attaching hardware is
tightened securely - otherwise injury or damage may occur.

Removing/Installing the Trigger Release Lever with Cable

NOTE: For this procedure, refer to FIGURE 10.1.
Removing
1. Remove the mounting screw that secures the trigger release housing to the back cane.
2. Cut the tie wraps that secure the two cables together.
3. Remove the two mounting screws that secure the gear sector to the gear rack.
Installing
1. Secure the trigger release housing to the back cane with mounting screw. Tighten securely.
2. Secure the gear sector to the gear rack with two mounting screws. Tighten securely.
3. Secure the two cables together with three tie wraps in the locations shown.
L
DETAIL "A"
Mounting
Back Cane
Screw
NOTE: Housing secures to
stroller handle in the same
manner.
Part No 1160889
WARNING
Tie
Wraps
FIGURE 10.1
97
SECTION 10—TILT
See Detail "A" (Back Cane
not shown for clarity)
Solara®3G/Spree 3G