Replacing Usb Charger; Checking Cable; Cable Routing; Lighting Unit - Invacare TDX SP2 Service Manual

Invacare® TDX® SP2 Series
7. Remove nuts (3).
8. Replace strip fuse.
Installing main fuse
1. Install parts in reverse order.
2. Test all functions.
Make sure to press two parts of fuse holder
shroud together until it snaps.
If older fuseholder version is used, lock
fuseholder with UL94V0 cable tie.

6.7.14 Replacing USB charger

• 4 mm Allen wrench
When charger overheats, it stops working. Rail under
the seat serves to dissipate heat.
• Always mount USB charger in first third of the
rail of telescopic seat frame.
Removing USB charger
1. Loosen and remove screw D including washer C.
2. Take off USB charger B from rail of telescopic seat
frame A.
3. Replace USB charger.
Installing USB charger
1. Install parts in reverse order.

6.7.15 Checking cable

• 5/8" Allen key
• Size 2 Phillips screwdriver
• Oblique pliers
• Cable ties
38
1.
Remove shrouds, disconnect battery plugs and pull
batteries out of battery compartment as described in
6.7.5 Making batteries accessible, page 32.
2. Check fuse cable (1), battery cable (2) and battery plug
(3) for visible damage and crushing locations.
3. Replace any damaged cables.
4.
The position of the plugs is different for other
electronic modules. The procedure for checking
is otherwise identical. The position of the plugs
is described in revision 11 of this manual or in
LiNX Service Manual".
Check all cables for visible damage and crushing
locations. Replace any damaged cables.
5. Pull each plug carefully. Plug should not come out of
socket.
6. If one of plugs is loose, press it back into socket with
light pressure. Plug must engage.
7. Checked to make sure that plug is now firmly in its
socket. If not, repeat previous step.
8. Install parts in reverse order.
9. Test all functions.

6.7.16 Cable routing

• Size 2 Phillips screwdriver
• Oblique pliers
• Cable ties
1. Remove rear shroud as described in 6.6.2 Removing rear
shroud, page 30.
2. When routing cables in rear section, make sure that rear
wheel stabilizers are movable.
3.
Fix cable with cable ties at locations marked A.
4. Make sure cable has enough play so that all movable
parts can move freely without stretching, clamping or
chafing cable.
5. Route cable in the same manner underneath seat and
control shroud.

6.8 Lighting unit

6.8.1 Replacing front bulb (conventional lighting system)
• Size 2 Phillips screwdriver
1532486-L