•
Carefully note the location of the cable and the connection locations of the various plugs.
Either mark each plug and socket, or take a photograph with a digital camera.
•
The pictures show the power module (4), the optional lighting PCB (2) and the optional
actuator modules (1) & (3).
•
Pull the plug (1) out of the power module.
•
Loosen the two nuts (2) with a 8 mm socket spanner.
•
Remove the power module by pulling it backwards from the guides.
•
Replace the power module.
Refitting the power module:
•
Refit the parts in reverse order.
•
Plug all the plugs into their old positions.
•
Select the drive program as described in chapter 8.4.6.
•
If a new software version is available, update the drive program as described in Chapter 8.4.7.
•
Adapt the drive program using the programming software if necessary.
•
To conclude, check all the mobility aid functions.
63