8.11.6 Fitting the handlebar
Requirements:
• 4 mm Allen key
•
•
Loosen and remove the six Allen screws (3) on the plastic cover.
•
Remove the plastic cover (2).
•
Remove the covers on the washer recesses (5).
•
Arrange the handlebar (1) on the back section in such a way that the boreholes coincide with
the tapped holes in the back section.
•
Fit the four Allen screws (4) incl. the washers (5) and tighten the screws.
•
Refit the plastic cover.
•
Refit the six Allen screws (3) and tighten them.
99