Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Dodge 2015 Charger SRT 392 Operating Instructions Manual

Programming The Memory Feature

NOTE:
Saving a new memory profile will erase an
existing profile from memory.
To create a new memory profile, perform the
following:
1. Place the vehicles ignition to the ON/RUN
position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, adjust-
able pedals [if equipped], power tilt and
telescopic steering column [if equipped], and
radio station presets).
3. Push and release the SET (S) button on the
memory switch.
4. Within five seconds, push and release the
MEMORY button 1 or 2. The Drivers Infor-
mation Display (DID) will display which
memory position has been set.
NOTE:
• Memory profiles can be set without the
vehicle in PARK, but the vehicle must be
in PARK to recall a memory profile.
• To set a memory profile to your RKE
transmitter, refer to "Linking And Unlink-
ing The Remote Keyless Entry Transmit-
ter To Memory" in this section.
Linking And Unlinking The Remote
Keyless Entry Transmitter To
Memory
Your RKE transmitters can be programmed to
recall one of two pre-programmed memory pro-
files by pushing the UNLOCK button on the
RKE transmitter.
NOTE:
Before programming your RKE transmitters
you must select the "Memory To FOB" or "Per-
sonal Settings Linked To Fob" feature through
the Uconnect® system screen. Refer to
"Uconnect® Settings" in "Understanding Your
Instrument Panel" for further information.
To program your RKE transmitters, perform the
following:
1. Place the vehicles ignition to the OFF posi-
tion.
2. Select desired memory profile (1) or (2). The
system will recall any stored settings for this
profile. Wait for the system to complete the
memory recall before continuing to Step 3.
NOTE:
If a memory profile has not already been set,
refer to Programming The Memory Feature
in this section for instructions on how to set
a memory profile.
3. Once the profile has been recalled, push and
release the SET (S) button on the memory
switch, then push and release button (1) or
(2) accordingly. "Memory Profile Set" (1 or 2)
will display in the Drivers Information Display
(DID).
4. Push and release the LOCK button on the
RKE transmitter within 10 seconds.
79