Normal Starting - Dodge 2015 Charger SRT 392 Operating Instructions Manual

Normal Starting

Using The ENGINE START/STOP Button
1. The transmission must be in PARK or NEU-
TRAL.
2. Push and hold the brake pedal while pushing
the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after 10
seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, push the button
again.
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or
pressing the accelerator pedal.
200
To Turn Off The Engine Using ENGINE
START/STOP Button
1. Place the shift lever/gear selector in PARK,
then push and release the ENGINE START/
STOP button.
2. The ignition switch will return to the OFF
position.
3. If the shift lever/gear selector is not in PARK,
the ENGINE START/STOP button must be
held for two seconds or three short pushes in
a row with the vehicle speed above 5 mph
(8 km/h) before the engine will shut off. The
ignition switch position will remain in the
ACC position until the shift lever/gear selec-
tor is in PARK and the button is pushed twice
to the OFF position. If the shift lever/gear
selector is not in PARK and the ENGINE
START/STOP button is pushed once, the
DID will display a "Vehicle Not In Park"
message and the engine will remain running.
Never leave a vehicle out of the PARK
position, or it could roll.
NOTE:
If the ignition switch is left in the ACC or
RUN (engine not running) position and the
transmission is in PARK, the system will
automatically time out after 30 minutes of
inactivity and the ignition will switch to the
OFF position.
ENGINE START/STOP Button Functions —
With Driver's Foot OFF The Brake Pedal (In
PARK Or NEUTRAL Position)
The ENGINE START/STOP button operates
similar to an ignition switch. It has three posi-
tions, OFF, ACC, RUN. To change the ignition
switch positions without starting the vehicle and
use the accessories follow these steps:
1. Starting with the ignition in the OFF position:
2. Push the ENGINE START/STOP button
once to change the ignition to the ACC
position.
3. Push the ENGINE START/STOP button a
second time to change the ignition to the
RUN position.