Dodge 2015 Charger SRT 392 Operating Instructions Manual page 285

CAUTION!
• Mixing of engine coolant (antifreeze) other
than specified Organic Additive Technol-
ogy (OAT) engine coolant (antifreeze),
may result in engine damage and may
decrease corrosion protection. Organic
Additive Technology (OAT) engine coolant
is different and should not be mixed with
Hybrid Organic Additive
(HOAT) engine coolant (antifreeze) or any
"globally compatible" coolant (antifreeze).
If a non-OAT engine coolant (antifreeze) is
introduced into the cooling system in an
emergency, the cooling system will need to
be drained, flushed, and refilled with fresh
OAT coolant (conforming to MS.90032), by
an authorized dealer as soon as possible.
282
CAUTION! (Continued)
• Do not use water alone or alcohol-based
engine coolant (antifreeze) products. Do
not use additional rust inhibitors or antirust
products, as they may not be compatible
with the radiator engine coolant and may
plug the radiator.
• This vehicle has not been designed for use
Technology with propylene glycol-based engine cool-
ant (antifreeze). Use of propylene glycol-
based engine coolant (antifreeze) is not
recommended.
Adding Coolant
Your vehicle has been built with an improved
engine coolant (OAT coolant conforming to
MS.90032) that allows extended maintenance
intervals. This engine coolant (antifreeze) can
be used up to ten years or 150,000 miles
(Continued)
(240,000 km) before replacement. To prevent
reducing this extended maintenance period, it is
important that you use the same engine coolant
(OAT coolant
throughout the life of your vehicle.
conforming to MS.90032)
Please review these recommendations for us-
ing Organic Additive Technology (OAT) engine
coolant (antifreeze) that meets the require-
ments of Chrysler Material Standard MS.90032.
When adding engine coolant (antifreeze):
• We recommend using MOPAR® Antifreeze/
Coolant 10 Year/150,000 Mile Formula OAT
(Organic Additive Technology) that meets the
requirements of Chrysler Material Standard
MS.90032.
• Mix a minimum solution of 50% OAT engine
coolant that meets the requirements of
Chrysler Material Standard MS.90032 and
distilled water. Use higher concentrations
(not to exceed 70%) if temperatures below
−34° F (−37° C) are anticipated.
• Use only high purity water such as distilled or
deionized water when mixing the water/
engine coolant (antifreeze) solution. The use
of lower quality water will reduce the amount
of corrosion protection in the engine cooling
system.
Please note that it is the owner's responsibility
to maintain the proper level of protection