Programming The Memory Feature - Dodge Charger 392 SRT Hellcat 2017 Owner's Manual

112 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE: If your vehicle is equipped with two key fobs, one
key fob can be linked to memory position 1 and the other
key fob can be linked to memory position 2.
The memory seat switch is located on the driver's door
trim panel. The switch consists of three buttons: The set (S)
button, which is used to activate the memory save func-
tion, and the memory (1) and (2) buttons, which are used to
recall either of two pre-programmed memory profiles.
Memory Seat Switches

Programming The Memory Feature

NOTE: Saving a new memory profile will erase an existing
profile from memory.
To create a new memory profile, perform the following:
1. Place the vehicle's ignition to the ON/RUN position.
2. Adjust all memory profile settings to desired prefer-
ences (i.e., seat, side mirror, power tilt and telescopic
steering column [if equipped], and radio station pre-
sets).
3. Push and release the set (S) button on the memory
switch.
4. Within five seconds, push and release memory button
(1) or memory button (2). The instrument cluster display
will show which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless Entry Key
Fob To Memory" in this section for further information.