Dodge 2015 Charger SRT 392 Operating Instructions Manual page 181

NOTE:
Launch RPM Set-Up cannot be accessed
unless Launch Mode is deactivated.
Launch RPM Set-Up
To adjust the Launch RPM, drag the slider bar
or press the arrows on the touchscreen to
adjust the holding RPM. The launch RPM limit is
(1500–3500 RPM).
For further information refer to "Drive Modes" in
"Starting and Operating".
178
Shift Light
Shift Light
To actuate the Shift Light feature, press the
"Shift Light" button on the touchscreen, then
press the "Shift Light On" button on the touch-
screen. Activation is shown on the Driver Infor-
mation Display (DID). Pressing the "Shift Light
RPM Set-Up" button on the touchscreen will
take you to the Shift Light RPM Set-Up screen.
Shift Light RPM Set-Up
The Shift Light RPM Set-Up allows you to set
the shift light to actuate for gears 1, 2, 3, 4, and
5-8. Pressing and releasing the up/down arrow
buttons on the touchscreen above and below
each listed gear, the RPM values will change in
increments of 250 RPM. Pressing and holding
the arrows will change the RPM values in
increments of 500 RPM, ranging from 2000–
6000 RPM. The Shift Light setup screen may
only be accessed if the feature is enabled,
press the "Reset to factory default" button on
the touchscreen to change back to factory set-
tings, or press the "Shift Light Off" button on the
touchscreen to turn the system off completely.