Instrument Cluster Descriptions - Dodge 2015 Charger SRT 392 Operating Instructions Manual

INSTRUMENT CLUSTER
DESCRIPTIONS
1. Tachometer
The red segments indicate the maximum per-
missible engine revolutions per minute (RPM x
1000) for each gear range. Ease up on the
accelerator before reaching the red area. The
transition of the red line starts 500 RPM prior to
the actual redline. 6.2L SC redline = 6250 RPM
and 6.4L redline = 6400 RPM.
2. High Beam Indicator
This indicator will turn on when the
high beam headlights are on. Push the
multifunction lever away from the
steering wheel to switch the headlights to high
beam.
3. Brake Warning Light
This light monitors various brake func-
tions, including brake fluid level and
parking brake application. If the brake
light turns on, it may indicate that the parking
brake is applied, that the brake fluid level is low,
or that there is a problem with the anti-lock
brake system reservoir.
If the light remains on when the parking brake
has been disengaged, and the fluid level is at
the full mark on the master cylinder reservoir, it
indicates a possible brake hydraulic system
malfunction. In this case, the light will remain on
until the condition has been corrected.
The dual brake system provides a reserve
braking capacity in the event of a failure to a
portion of the hydraulic system. A leak in either
half of the dual brake system is indicated by the
Brake Warning Light which will turn on when the
brake fluid level in the master cylinder has
dropped below a specified level.
The light will remain on until the cause is
corrected.
NOTE:
The light may flash momentarily during
sharp cornering maneuvers which change
fluid level conditions. The vehicle should
have service performed, and the brake fluid
level checked.
If brake failure is indicated, immediate repair is
necessary.
WARNING!
Driving a vehicle with the brake light on is
dangerous. Part of the brake system may
have failed. It will take longer to stop the
vehicle. You could have a collision. Have the
vehicle checked immediately.
Vehicles equipped with the Anti-Lock Brake
System (ABS) are also equipped with Electronic
Brake Force Distribution (EBD). In the event of
an EBD failure, the Brake Warning Light will turn
on along with the ABS Light. Immediate repair
to the ABS system is required.
Operation of the Brake Warning Light can be
checked by placing the ignition from the OFF
position to the ON/RUN position. The light
should illuminate for approximately two sec-
onds. The light should then turn off unless the
parking brake is applied or a brake fault is
detected. If the light does not illuminate, have
the light inspected by an authorized dealer.
137