Changing Lanesense Status - Dodge 2015 Charger SRT 392 Operating Instructions Manual

indicator changes from solid green to solid
yellow. At this time torque is applied to the
steering wheel in the opposite direction of the
lane boundary.
• For example: If approaching the left side of
the lane the steering wheel will turn to the
right.
Lane Sensed (Solid Yellow Thick Line, Solid
Yellow Thin Line/Solid Yellow Indicator)
• When the LaneSense system senses the
lane has been approached and is in a lane
departure situation, the left thick lane line
flashes yellow (on/off) and the left thin line
remains solid yellow. The LaneSense indica-
114
tor changes from solid yellow to flashing
yellow. At this time torque is applied to the
steering wheel in the opposite direction of the
lane boundary.
• For example: If approaching the left side of
the lane the steering wheel will turn to the
right.
Lane Approached (Flashing Yellow Thick Line,
Solid Yellow Thin Line/Flashing Yellow
Indicator)
NOTE:
The LaneSense system operates with the
similar behavior for a right lane departure.

Changing LaneSense Status

The LaneSense system settings can be config-
ured through the Uconnect® system screen.
Follow these steps to change the LaneSense
settings:
1. Push the "Controls" button on touchscreen
located on the bottom of the Uconnect®
display.
2. Push the "Settings" button.
3. Push the "Safety & Driving Assistance" but-
ton.
When in the Safety & Driving Assistance
screen, you can configure the intensity of the
torque warning and the warning zone sensitivity
(early/late) through the personalization settings.
NOTE:
• When enabled the system operates above
37 mph (60 km/h) and below 112 mph
(180 km/h).
• Use of the turn signal suppresses the
warnings.