Programming The Memory Feature; Linking And Unlinking The Key Fob To; Memory - Dodge CHARGER 2020 Owner's Manual

30 GETTING TO KNOW YOUR VEHICLE
NOTE:
Your vehicle is equipped with two key fobs,

each can be linked to either memory position
1 or 2.
Be sure to program the radio presets prior to

programming the memory settings.
The memory setting switch is located on the
driver's door trim panel. The switch consists of
three buttons:
The set (S) button, which is used to activate

the memory save function.
The (1) and (2) buttons which are used to

recall either of two pre-programmed memory
profiles.
Memory Setting Switches

Programming The Memory Feature

To create a new memory profile, perform the
following:
NOTE:
Saving a new memory profile will erase the
selected profile from memory.
1. Place the vehicle's ignition in the ON/RUN
position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column (if
equipped), and radio station presets).
3. Push the set (S) button on the memory
switch, and then push the desired memory
button (1 or 2) within five seconds. The
instrument cluster display will display which
memory position is being set.
NOTE:
Memory profiles can be set without the vehicle
in PARK, but the vehicle must be in PARK to
recall a memory profile.

Linking And Unlinking The Key Fob To

Memory

Your remote keyless entry key fob can be
programmed to recall one of two saved memory
profiles with a push of the unlock button on the
key fob.
NOTE:
Before programming your key fobs you must
select the "Personal Settings Linked To Fob"
feature through the Uconnect system screen.
Refer to "Uconnect Settings" in "Multimedia"
for further information.
To program your key fob, perform the following:
1. Place the vehicle's ignition in the OFF
position.
2. Select the desired memory profile 1 or 2.
3. Push and release the set (S) button on the
memory switch, then within five seconds
push and release the button labeled (1) or
(2) accordingly. "Memory Profile Set" (1 or
2) will display in the instrument cluster
display.
4. Push and release the lock button on the key
fob within 10 seconds.