Lanesense - If Equipped; Lanesense Operation; Turning Lanesense On Or Off; Lanesense Warning Message - Dodge 2015 Charger SRT 392 Operating Instructions Manual

LANESENSE — IF EQUIPPED

LaneSense Operation

The LaneSense system is operational at
speeds above 37 mph (60 km/h) and below
112 mph (180 km/h). The LaneSense system
uses a forward looking camera to detect lane
markings and measure vehicle position within
the lane boundaries.
When both lane markings are detected and the
driver unintentionally drifts out of the lane (no
turn signal applied), the LaneSense system
provides a haptic warning in the form of torque
applied to the steering wheel to prompt the
driver to remain within the lane boundaries. If
the driver continues to unintentionally drift out of
the lane, the LaneSense system provides a
visual warning through the Driver Information
Display (DID) to prompt the driver to remain
within the lane boundaries.
The driver may manually override the haptic
warning by applying torque into the steering
wheel at any time.
When only a single lane marking is detected
and the driver unintentionally drifts across the
112
lane marking (no turn signal applied), the La-
neSense system provides a visual warning
through the DID to prompt the driver to remain
within the lane. When only a single lane marking
is detected, a haptic (torque) warning will not be
provided.
NOTE:
When operating conditions have been met,
the LaneSense system will monitor if the
driver's hands are on the steering wheel and
provides an audible warning to the driver
when the driver's hands are not detected on
the steering wheel. The system will cancel if
the driver does not return their hands to the
wheel.

Turning LaneSense ON Or OFF

The default status of LaneSense is "OFF".
The LaneSense button is located on the center
stack below the Uconnect® display.
To turn the LaneSense system ON,
push the LaneSense button to turn
the system ON (LED turns off). A "Lane Sense
On" message is shown in the DID.
To turn the LaneSense system OFF, push the
LaneSense button once to turn the system OFF
(LED turns on).
NOTE:
The LaneSense system will retain the last
system state ON or OFF from the last igni-
tion cycle when the ignition is changed to
the ON/RUN position.

LaneSense Warning Message

The LaneSense system will indicate the current
lane drift condition through the Driver Informa-
tion Display (DID).
7.0 Driver Information Display (DID) Screen
— If Equipped
When the LaneSense system is ON; the lane
lines are gray when both of the lane boundaries
have not been detected and the LaneSense
indicator is solid white.