Customer Key Programming; General Information; Vehicle Security Alarm - If Equipped; Rearming Of The System - Dodge 2015 Charger SRT 392 Operating Instructions Manual

NOTE:
When having the Sentry Key® Immobilizer
System serviced, bring all vehicle Key Fobs
with you to the authorized dealer.

Customer Key Programming

Programming Key Fobs or RKE transmitters
may be performed at an authorized dealer.

General Information

The Sentry Key® operates on a carrier fre-
quency of 433.92 MHz. The Sentry Key® Im-
mobilizer system is subject to the following
conditions:
• This device may not cause harmful interfer-
ence.
• This device must accept any interference
that may be received, including interference
that may cause undesired operation.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The Vehicle Security Alarm monitors the vehicle
doors for unauthorized entry and the Keyless
Enter-N-Go™ START/STOP button for unau-
14
thorized operation. While the Vehicle Security
Alarm is armed, interior switches for door locks
and decklid release are disabled. If something
triggers the alarm, the Vehicle Security Alarm
will provide the following audible and visible
signals: the horn will pulse, the park lamps
and/or turn signals will flash, and the Vehicle
Security Light in the instrument cluster will flash.

Rearming Of The System

If something triggers the alarm, and no action is
taken to disarm it, the Vehicle Security Alarm
will turn the horn off after 29 seconds, 5 sec-
onds between cycles, up to 8 cycles if the
trigger remains active and then the Vehicle
Security Alarm will rearm itself.

To Arm The System

Follow these steps to arm the Vehicle Security
Alarm:
1. Make sure the vehicles ignition is placed in
the "OFF" position (refer to "Starting Proce-
dures" in "Starting And Operating" for further
information).
• Make sure the vehicle ignition system is OFF.
2. Perform one of the following methods to lock
the vehicle:
• Push LOCK on the interior power door lock
switch with the driver and/or passenger door
open.
• Push the LOCK button on the exterior Pas-
sive Entry Door Handle with a valid Key Fob
available in the same exterior zone (refer to
"Keyless Enter-N-Go™" in "Things To Know
Before Starting Your Vehicle" for further
information).
• Push the LOCK button on the Remote Key-
less Entry (RKE) transmitter.
3. If any doors are open, close them.

To Disarm The System

The Vehicle Security Alarm can be disarmed
using any of the following methods:
• Push the UNLOCK button on the Remote
Keyless Entry (RKE) transmitter.