To Cancel; To Turn Off; To Resume; To Vary The Speed Setting - Dodge 2015 Charger SRT 392 Operating Instructions Manual

To Cancel

The following conditions cancel the system:
• The brake pedal is applied.
• The CANCEL button is pushed.
• An Anti-Lock Brake System (ABS) event
occurs.
• The shift lever/gear selector is removed from
the Drive position.
• The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
• The vehicle parking brake is applied.
• Driver seatbelt is unbuckled at low speeds.
• Driver door is opened at low speeds.
NOTE:
• If your vehicle stays at standstill for lon-
ger than two seconds, then the system
will cancel and the brake force will be
ramped-out. The driver will have to apply
the brakes to keep the vehicle at a stand-
still.
• ACC cannot be resumed if there is a
stationary vehicle in-front of your vehicle
in close proximity.

To Turn Off

The system will turn off and erase the set speed
in memory if:
• The Normal (Fixed Speed) Electronic Speed
Control ON/OFF button is pushed.
• The ignition is turned off.
• The Adaptive Cruise Control (ACC) On/Off
button is pushed.

To Resume

If there is a set speed in memory push the RES
(resume) button and then remove your foot from
the accelerator pedal. The DID will display the
last set speed.
NOTE:
• If your vehicle stays at standstill for longer
than two seconds, then the system will
cancel and the brake force will be ramped-
out. The driver will have to apply the brakes
to keep the vehicle at a standstill.
• ACC cannot be resumed if there is a
stationary vehicle in-front of your vehicle
in close proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.

To Vary The Speed Setting

To Increase Speed
While ACC is set, you can increase the set
speed by pushing the SET + button.
The drivers preferred units can be selected
through the instrument panel settings if
equipped. Refer to "Understanding Your Instru-
ment Panel" for more information. The speed
99