Memory Position Recall; Easy Entry/Exit Seat - Dodge 2015 Charger SRT 392 Operating Instructions Manual

NOTE:
Your RKE transmitters can be unlinked from
your memory settings by pushing the SET
(S) button, and within 10 seconds, followed
by pushing the UNLOCK button on the RKE
transmitter.

Memory Position Recall

NOTE:
The vehicle must be in PARK to recall
memory positions. If a recall is attempted
when the vehicle is not in PARK, a message
will display in the Drivers Information Dis-
play (DID).
To recall the memory settings for driver 1, push
MEMORY button number 1 on the driver's door
or the UNLOCK button on the RKE transmitter
linked to memory position 1.
NOTE:
If the vehicle is equipped with Passive Entry,
the memory settings will be recalled with a
Passive Entry Unlock into the driver's door
using the Key Fob linked to position 1.
80
To recall the memory setting for driver 2, push
MEMORY button number 2 on the driver's door
or the UNLOCK button on the RKE transmitter
linked to memory position 2.
NOTE:
If the vehicle is equipped with Passive Entry,
the memory settings will be recalled with a
Passive Entry Unlock into the driver's door
using the Key Fob linked to position 2.
A recall can be cancelled by pushing any of the
MEMORY buttons (S, 1, or 2) on the driver's
door during a recall. When a recall is cancelled,
the driver's seat, adjustable
equipped), and power tilt and telescopic steer-
ing column (if equipped) stop moving. A delay of
one second will occur before another recall can
be selected.

Easy Entry/Exit Seat

This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you cycle the vehicles ignition to the OFF
position.
• When you cycle the vehicles ignition to the
OFF position, the driver seat will move about
2.4 in (60 mm) rearward if the driver seat
position is greater than or equal to 2.7 in
(67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you cycle the vehicles ignition to the ACC or
RUN position.
• The Easy Entry/Easy Exit feature is disabled
pedals (if
when the driver seat position is less than 0.9
in (22.7 mm) forward of the rear stop. At this
position, there is no benefit to the driver by
moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.