Turn Signals; Lane Change Assist; High/Low Beam Switch; Flash-To-Pass - Dodge 2015 Charger SRT 392 Operating Instructions Manual

Turn Signals

Move the multifunction lever up or down and the
arrows on each side of the instrument cluster
flash to show proper operation of the front and
rear turn signal lights.
NOTE:
• If either light remains on and does not
flash, or there is a very fast flash rate,
check for a defective outside light bulb. If
an indicator fails to light when the lever is
moved, it would suggest that the indicator
bulb is defective.
• A "Turn Signal On" message will appear
in the Drivers Information Display (DID)
and a continuous chime will sound if the
vehicle is driven more than 1 mi (1.6 km)
with either turn signal on.

Lane Change Assist

Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn
off.

High/Low Beam Switch

Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
multifunction lever toward you to switch the
headlights back to low beam.

Flash-To-Pass

You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will turn on the high beam
headlights until the lever is released.
NOTE:
If the multifunction lever is held in the
flash-to pass position for more than 20 sec-
onds, the high beams will shut off.
Front Map/Reading Lights — If
Equipped
Lights are mounted in the overhead console.
Each light can be turned on by pushing the
switch on either side of the console. These
buttons are backlit for night time visibility.
Front Map/Reading Lights
85