Valet Mode - Dodge 2015 Charger SRT 392 Operating Instructions Manual

Valet Mode

Valet Mode Activation
To enter Valet Mode press the "Valet" button on
the touchscreen and a popup screen will ask
you if you would like to enter Valet Mode, after
selecting "Yes" you will be asked to enter a 4
digit PIN code. The PIN code is not set, so you
are free to select any 4 digit numeric combina-
tion that will be easy to remember.
While in Valet Mode the following vehicle con-
figurations are set and locked to prevent unau-
thorized modification:
• Engine limited to the lowest power output
state.
• Transmission locks out access to first gear
and up-shifts earlier than normal.
• Traction, Steering, and Suspension are set to
their STREET settings.
• Steering wheel paddle shifters are disabled.
• The Drive Mode interface is not available.
Pressing the SRT button on the touchscreen
will display the unlock keypad.
• The ESC Off button is disabled.
• The Launch Control button is disabled.
Valet Mode Deactivation
To exit Valet Mode you must enter the same 4
digit PIN that was used to enter the mode. The
unlock keypad can be accessed by either push-
ing the SRT button on the faceplate, or pressing
the "Valet Mode Active – Press Here to Exit"
button on the touchscreen.
Valet Mode Deactivation PIN
The Valet Mode Deactivation key pad will then
prompt you for your 4 digit PIN code, enter your
PIN code and press the "OK" button on the
touchscreen. Your vehicle will return to the
default state after a key cycle.
179