Dodge 2015 Charger SRT 392 Operating Instructions Manual page 160

further information, refer to "Forward Collision
Warning (FCW) With Mitigation" in "Under-
standing The Features Of Your Vehicle."
• LaneSense Warning — If Equipped
When this feature is selected, it sets the dis-
tance at which the steering wheel will provide
feedback for potential lane departures. The
LDW sensitivity can be set to provide either an
"Early," "Medium," or "Late" warning zone start
point.
For further information, refer to "LaneSense
Warning (LDW)" in "Understanding The Fea-
tures Of Your Vehicle".
• LaneSense Strength — If Equipped
When this feature is selected, it sets the
strength of the steering wheel feedback for
potential lane departures. The amount of direc-
tional torque the steering system can apply to
the steering wheel to correct for vehicle lane
departure can be set at "Low," "Medium" or
"High."
For further information, refer to "Lane Departure
Warning (LDW)" in "Understanding The Fea-
tures Of Your Vehicle".
• ParkSense®
The ParkSense® system will scan for objects
behind the vehicle when the transmission shift
lever is in REVERSE and the vehicle speed is
less than 11 mph (18 km/h). It will provide an
alert (audible and/or visual) to indicate the prox-
imity to other objects. The system can be en-
abled with Sound Only, or Sound and Display.
To change the ParkSense® status, press and
release the "Sound Only" or "Sound and Dis-
play" button. Then press the back arrow button
on the touchscreen. Refer to "ParkSense®" in
"Understanding The Features Of Your Vehicle"
for system function and operating information.
• Front ParkSense® Volume
The Front ParkSense® Chime Volume settings
can be selected from the DID or Uconnect®
System. The chime volume settings include
LOW, MEDIUM, and HIGH. The factory default
volume setting is MEDIUM. To make your se-
lection, press the "Front ParkSense® Vol." but-
ton on the touchscreen, until a check-mark
appears next to setting, indicating that the set-
ting had been selected. Press the back arrow
button on the touchscreen to return to the
previous menu. ParkSense® will retain its last
known configuration state through ignition
cycles.
• Rear ParkSense® Volume
The Rear ParkSense® Chime Volume settings
can be selected from the DID or Uconnect®
System. The chime volume settings include
LOW, MEDIUM, and HIGH. The factory default
volume setting is MEDIUM. To make your se-
lection, press the "Rear ParkSense® Vol." but-
ton on the touchscreen, until a check-mark
appears next to setting, indicating that the set-
ting had been selected. Press the back arrow
button on the touchscreen to return to the
previous menu. ParkSense® will retain its last
known configuration state through ignition
cycles.
• Tilt Side Mirrors In Reverse
When this feature is selected, the exterior
sideview mirrors will tilt downward when the
157