Icomfort Mobile Setup Application; Operating System Requirements; Commissioning - Lennox iComfort S30 Installation And Setup Manual

S
Steady amber (briefly) while the Smart Hub conducts self tests and boots
up.
S
Flashing amber while software or firmware updates for an iComfort
system component or a connected field-upgradable HVAC asset is being
transferred from files on a flash drive plugged into the Smart Hub USB port.
S
Steady blue while the Smart Hub conducts checks on its internal Wi-Fi
module and remote HVAC assets. (Icon indicators show progress.)
S
Flashing blue when the Smart Hub is attempting a Lennox-managed local
network connection with another Smart Hub in the home or with a mobile
device running the iComfort
S
Steady blue when the Smart Hub is connected to a mobile device running
the iComfort Mobile Setup application through a Lennox-managed local
network connection. (This is considered a transient state because the
mobile device will disconnect from the Lennox-managed network when the
task at hand is complete.)

IComfort Mobile Setup Application

This application tool is used by dealers to commission a S30 system using
Wi-Fi enabled mobile device.

Operating System Requirements

The iComfort Mobile Setup application is available for both IOS 6.0 and higher
(App Store) and Android 4.1 and higher (Google Play).

Commissioning

To commission a system using the iComfort Mobile Setup application:
A. Download and install the iComfort Mobile Setup application.
NOTE - It is recommend that when using the iComfort Mobile Setup
application to commission the system, remove the HD Display from the
Mag-Mount before starting. Once commissioning is completed,
reattached the HD Display to the Mag-Mount.
B. Go to the Smart Hub and press the center Lennox button once.
®
Mobile Setup application.
®
S30
LENNOX CENTER
BUTTON (LED RING)
C. The center ring LED will start blinking green for two minutes. During
that time the Smart Hub will broadcast its Wi-Fi identifier (SSID).
D. Go to your mobile device's Wi-Fi connection tool and locate the Smart
Hub Wi-Fi broadcast identifier. The identifier (SSID) is
Direct E300-5200 for example.
NOTE - Refer to your mobile device's owners manual on how to use
your Wi-Fi Connection tool.
E. To connect to the Smart Hub use the last eight digits of the Smart Hub
SSID as the password (E3005200).
F. Once connected to the mobile device the Smart Hub center ring LED
turns solid green.
G. Start the iComfort Mobile Setup application and make sure you
connect to the correct Smart Hub by checking the serial number.
NOTE - The serial number check is only needed if multiple Smart Hubs are
shown. For example if you have three systems and have completed
commissioning of two and while on third unit, the other two Smart Hubs
connection data is still listed in the iComfort Mobile Setup application. If you
chose the wrong one it will not connect because it would have already stopped
broadcasting its connection signal.
H. Touch the remote in tab on the iComfort Mobile Setup application
home screen. This will take you to the commissioning screen.
NOTE - If the system has not been commissioned it will go to
commissioning screen. If the system has already been commissioned
it will go to dealer control center.
17