IMPORTANT: PRIOR TO RUNING THE ICOMFORT S30 INSTALLER
SETUP, AIR HANDLER ELECTRIC HEAT MUST BE MANUALLY
CONFIGURED! SEE PAGE 14.
The following procedures are written for the installer setup using the HD
Display.
When power is first applied to the system all communicating devices attached
to the system (air handler or furnace, outdoor unit or zoning control) will
automatically be configured using optimal factory default settings based on
system type, capacity and other configuration considerations.
Boot-up Screen
When power is applied to the system, the HD Display or sometimes referred to
as thermostat will display a welcome screen. For the iComfort Mobile Setup
application, refer to page 17 for establishing a wireless connection between the
iComfort Mobile Setup application and Smart Hub.
If there is an issue with communication between any component attached to the
iComfort® S30, a critical alert message will appear on the screen. The alert
message will provide detail information concerning the possible cause. Once
the issue is corrected and power is restored to the system the first screen in the
initial setup sequence will appear.
your thermostat cannot connect to the
Please make sure the equipment is wired
for assistance please contact
INSTALLER SYSTEM SETUP
critical
equipment
correctly and reboot it
1-800-0-Lennox
try again
Low Battery Status
If a critical low battery screen is displayed, the system will automatically start
charging the HD Display internal battery. On the screen the word "charging" will
appear. Once "charging" disappears (typically 3 to 10 minutes) then the display
will automatically start-up.
Dealer Info
The first screen in the installer system setup sequence is the dealer information
screen. Here either the dealer ID and/or phone number can be added. When
the system is connected to the Internet, the remaining information is
automatically populated by the Lennox server. All information can be entered
manually if desired however.
NOTE - Not all information for this screen is viewable on a single screen. Use a
finger to swipe up to access the remaining information on the screen.
Information Required: Dealer ID and / or dealer phone number. Information
that can be manually entered is name, email website, dealer address which
includes address 1, address 2, city, state and zip/postal code. Once completed
touch continue.
Warning Screen: If either the Dealer ID or phone number is NOT provided, a
warning screen will appear. The warning screen will provide information on the
limitation imposed on the system if this information is not provided. Touch no
to return to the previous screen to complete the information requested or touch
yes to continue.
IMPORTANT: IF THE FOLLOWING INFORMATION IS NOT COMPLETED
®
THE ICOMFORT
S30 WILL NOT BE ASSOCIATED TO THE DEALER IN
DAVENET.
General Information
On this screen general information needs to be verified or changed. Touch any
item to change its contents. A pop-up screen will appear that will allow the
information to be added or changed.
19